01/12/2002 3:34PM
Just received the kit today and this is just part of the kit.
01/12/2002 4:48PM
Ready to start the new kit.
The front corners have to be cut out because the new front end is more rounded
than the stock Fiero.
The wiring is being reworked to eliminate the headlight motors.
This is the new front end being fitted to the car.
Just a different angle of the new front end of the car.
The hood is setting on top of the hinges (not bolted on) and needs to be fit properly.
The back part of the rear clip must be trimmed for the Fino. This part is
used only when you have a Finale (rear window)
The part near the rear window on the left side had to be cut out because it interfered
with the installation of the rear clip.
The body is starting to come together now.
Left front side view.
Left side.
Rear end.
Right side.
Front end.
Now that the body is on the car I will have to fine
tune it.
This is the hole in the rear bumper that I needed to cut for the license plate
holder.
This is the license plate holder ready to be glassed in.
The headlight cover will need to be cut. It overlaps the hood.
This is the headlight cover after cutting the scrap away.
The headlight cover in on, now I will have to sand it to fit the body.
This is the back of the rear clip where I fiber glassed in the license plate
holder.
The top part came in the kit and had to be cut out to fit into the hole I cut in
the rear clip.
This is how I had to install the rear clip because I did not have any help.
This is the rear clip back on the car
The car is together now, it needs finish sanding and fitting. The front is
4 1/4" and the rear is 5" high.
I am going to raise the front to 5" that will be a total drop from stock of
2 1/4".
This is my new wheels Enkei RS6 17x7. Tires are Nitto NT 555 Extreme Perf.
225/40ZR-17
Starting to install the front Park/Turn lights.
I have to make brackets to hold the Park light to the front end.
